Assigning Profisafe Address To Fail-Safe Modules With Simatic Safety - Siemens SIMATIC S7-1500/ET 200MP System Manual

Configuring

8.3 Assigning PROFIsafe address to fail-safe modules with SIMATIC Safety

Reference
You can find an overview of the most important documents and links to STEP 7 in the
following FAQ on the Internet
(https://support.industry.siemens.com/cs/de/de/view/65601780/en).
Configuring operation on PROFIBUS DP using a GSD file
If you want to configure the operation on the PROFIBUS DP with GSD file, you need to note
the following additional requirements:
Table 8- 2 Requirements for PROFIBUS DP with GSD file
I/O modules
Input/output modules 35 mm
Input/output modules 25 mm
Technology modules (TM)
Communications modules CM PtP
8.3 Assigning PROFIsafe address to fail-safe modules with SIMATIC
Safety
The PROFIsafe address is saved permanently on the electronic coding element of the
S7-1500/ET 200MP fail-safe modules. You can find additional information on the electronic
coding element in the section Replacing the coding element at the power connector of the
system power supply and load current supply (Page 310).
Note
The supply voltage L+ must be applied to the F-module during the assignment of the
PROFIsafe address (F-destination address together with F-source address).
For additional information on assigning the PROFIsafe address (F-destination address
together with the F-source address), refer to the SIMATIC Safety - Configuring and
Programming (https://support.automation.siemens.com/WW/view/en/54110126)
programming and operating manual and the online help.
206
Required firmware version
IM 155-5 DP ST as of ...
V1.0.0
V2.0.0
V2.0.0
V1.0.0
Required firmware version I/O mod-
ules as of ...
V2.0
V1.0
V1.1
V1.0.1
Automation system
System Manual, 01/2023, A5E03461182-AK