Installing The Interface Module - Siemens SIMATIC S7-1500/ET 200MP System Manual

Installation

6.7 Installing the interface module

Device damage caused by electrical fields or electrostatic discharge
Electrostatic sensitive devices (ESD) are individual components, integrated circuits, modules
or devices that can be damaged by electrostatic fields or electrostatic discharge.
NOTICE
Device damage caused by electrical fields or electrostatic discharge
Electrical fields or electrostatic discharge can cause function failures that result from
damaged individual components, integrated circuits, modules or devices.
• Pack, store, transport and send electronic components, modules or devices only in the
• Only touch components, modules and devices when you have grounded yourself with
• Place electronic components, modules and devices only on conducting surfaces (table
6.7 Installing the interface module
Introduction
The interface module connects the ET 200MP with the PROFINET IO/PROFIBUS DP.
The interface module exchanges data between the higher-level controller and the I/O
modules.
Requirements
The mounting rail is installed.
For a system power supply located to the left of the interface module, a U connector is
inserted on the back left.
Tools required
Screwdriver with 4.5 mm blade
144
original product packaging or in other suitable materials, e.g. conducting foam rubber or
aluminum foil.
one of the following measures:
– Wear an ESD wrist strap
– Wear ESD shoes or ESD grounding strips in ESD areas with a conducting floor
with ESD coating, conducting ESD plastic foam, ESD packing bag, ESD transport
container).
Automation system
System Manual, 01/2023, A5E03461182-AK