Installing The Cpu - Siemens SIMATIC S7-1500/ET 200MP System Manual

Installation

6.6 Installing the CPU

6.6 Installing the CPU
Introduction
The CPU executes the user program and supplies the electronics of the modules with power
via the backplane bus.
Requirements
The mounting rail is installed.
In a system power supply located on the left next to the CPU, a U connector is inserted on the
back right.
Note
Protective film
Please note that the CPU is supplied with a removable protective film on the display. You can
remove the protective film as required.
Tools required
Screwdriver with 4.5 mm blade
Installing the CPU
Watch video sequence (https://support.industry.siemens.com/cs/ww/en/view/78027451)
To install a CPU, follow these steps:
1. Insert a U-connector into the back right on the CPU.
2. Install the CPU to the mounting rail. Also push the CPU to the left system power supply if
necessary.
142
Automation system
System Manual, 01/2023, A5E03461182-AK