Connecting The Cpu/Interface Module To The Load Current Supply - Siemens SIMATIC S7-1500/ET 200MP System Manual

Wiring

7.8 Connecting the CPU/interface module to the load current supply

7.8 Connecting the CPU/interface module to the load current supply
Introduction
The load current supply is fitted with a plug-in 24 V DC output terminal (behind the front
cover at the bottom). You connect the cables for the supply voltage to the CPU/interface
module at this terminal.
Requirements
• Only wire the connection plug when the supply voltage is turned off.
• The connection plug for connecting the supply voltage to the CPU/interface module is
already mounted.
You can find additional information in the section Connecting the supply voltage (Page 167).
Tools required
3 to 3.5 mm screwdriver
170
Automation system
System Manual, 01/2023, A5E03461182-AK