Siemens SIMATIC S7-1500/ET 200MP System Manual page 138

Procedure
Mounting on the standard DIN rail 35 mm x 7.5 mm
To install DIN rail adapter on the standard DIN rail 35 mm x 7.5 mm, follow these steps:
1. Set the clamp onto the standard DIN rail.
2. The shorter transverse edge of the adapter frame points towards the cabinet or box wall (2).
3. Place the S7-1500/ET 200MP mounting rail on the adapter frame so that the groove in the
S7-1500/ET 200MP mounting rail matches the groove in the adapter frame.
Place the S7-1500/ET 200MP mounting rail with the adapter frame on the clamp (4).
4. Use screws to fasten the S7-1500/ET 200MP mounting rail to the DIN rail adapter and the
standard mounting rail (tightening torque 5 Nm to 6 Nm).
Figure 6-8 Mounting sequence of the DIN rail adapter to the DIN rail 35 mm x 7.5 mm or 35 mm x 15 mm
Automation system
System Manual, 01/2023, A5E03461182-AK
6.3 Installing the standard rail adapter
Installation
137