Installing Junos Pulse Gateway Components; Removing And Installing Faceplates; Installing The Mag-Sm160 Kit - Juniper Junos Pulse MAG2600 Hardware Manual

CHAPTER 8
Installing Junos Pulse Gateway
Components

Removing and Installing Faceplates

Related
Documentation

Installing the MAG-SM160 Kit

Copyright © 2014, Juniper Networks, Inc.
Removing and Installing Faceplates on page 41
Installing the MAG-SM160 Kit on page 41
Installing the MAG-SM360 Kit on page 43
Installing the MAG-SM161 Kit on page 44
Installing the MAG-SM361 Kit on page 45
Installing an AC Power Supply in the MAG6610 and MAG6611 on page 47
Installing a Fan Assembly in the MAG6610 and MAG6611 on page 48
Installing a Hard Drive in the MAG6610 or MAG6611 on page 48
Installing the Integrated Access Service Modules Overview on page 49
Installing a MAG-CM060 Chassis Management Card on page 50
Faceplates for the MAG6610 and MAG6611 are held in place by tabs. To remove a
faceplate, gently pry the faceplate from the chassis using your fingers or a flat-blade
screw driver. To install a faceplate, line up the faceplate with the open slot and push
gently until it clicks into place.
NOTE: Faceplates are required for proper airflow. If you remove a service
module and do not intend to replace it, cover the opening with a faceplate.
Installing the Integrated Access Service Modules Overview on page 49
Removing an Integrated Access Service Module on page 93
The MAG-SM160 kit includes:
One MAG-SM160 service module.
41