Using The Reset Button On The Service Modules - Juniper Junos Pulse MAG2600 Hardware Manual

Using the Reset Button on the Service Modules

Related
Documentation
Copyright © 2014, Juniper Networks, Inc.
If an installed service module becomes unresponsive, you can use the Reset button to
reboot that specific module. Service modules operate independently, so that pressing
the Reset button on one module does not interfere with any other installed service module.
NOTE: The Reset button is recessed to prevent it from being pressed
accidentally.
To press the Reset button, insert a small probe (such as a straightened paper clip) into
the pinhole on the front panel.
Monitoring the Junos Pulse Gateway Components Using LEDs on page 99
Chapter 10: Connecting the Junos Pulse Gateway
81