Ac Power Cord Specification; Ac Power Cord Specifications For The Mag6610 And Mag6611 Junos Pulse Gateway - Juniper Junos Pulse MAG2600 Hardware Manual

CHAPTER 6

AC Power Cord Specification

AC Power Cord Specifications for the MAG6610 and MAG6611 Junos Pulse Gateway

Copyright © 2014, Juniper Networks, Inc.
AC Power Cord Specifications for the MAG6610 and MAG6611 Junos Pulse
Gateway on page 35
Each AC power supply for the MAG6610 and MAG6611 Junos Pulse Gateway has a single
AC appliance inlet located on the power supply that requires a dedicated AC power feed.
Most sites distribute power through a main conduit that leads to frame-mounted power
distribution panels, one of which can be located at the top of the rack that houses the
Junos Pulse Gateway. An AC power cord connects each power supply to the power
distribution panel.
Each detachable AC power cord is 2.5 m (approximately 8 ft) long. The appliance coupler
at the female end of the cord inserts into the AC appliance inlet on the faceplate of the
AC power supply. The coupler type is C13, as described by the International
Electrotechnical Commission (IEC) standard 60320. The plug at the male end of the
power cord fits into the power source outlet that is standard for your geographical location.
NOTE: In North America, AC power cords must not exceed 4.5 m
(approximately 15 ft) in length, to comply with National Electrical Code (NEC)
Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical Code
(CEC) Section 4-010(3). The cords shipped with the Junos Pulse Gateway
are in compliance.
Country-specific power cords are shipped with each device.
CAUTION: The AC power cord for the Junos Pulse Gateway is intended for
use with the Junos Pulse Gateway only and not for any other use. This warning
is also localized in Japanese as shown in Figure 15 on page 36.
35