Mounting The Junos Pulse Gateway In A Recessed Position In A Rack Or Cabinet; Installing The Junos Pulse Gateway Mag2600 On A Desk; Installing The Mag2600 In The Mag-Rk1U4 Tray - Juniper Junos Pulse MAG2600 Hardware Manual

Related
Documentation

Mounting the Junos Pulse Gateway in a Recessed Position in a Rack or Cabinet

Related
Documentation

Installing the Junos Pulse Gateway MAG2600 on a Desk

Related
Documentation

Installing the MAG2600 in the MAG-RK1U4 Tray

Copyright © 2014, Juniper Networks, Inc.
Using the MAG-RK1U Mounting Kit on page 52
Using the MAG-RK2U Mounting Kit on page 57
Using the Mid-Ear Mounts on page 63
Installing the Junos Pulse Gateway in a Rack on page 51
Mounting the Junos Pulse Gateway in a Recessed Position in a Rack or Cabinet on
page 67
You can mount a Junos Pulse Gateway in a rack or cabinet such that the chassis is
recessed inside the rack from the rack front by 2 in. Use the front brackets in the provided
rack-mount kit to mount the chassis in a recessed position.
To mount the Junos Pulse Gateway in a recessed position on four posts, follow the same
instructions as for mounting on four posts.
NOTE: You cannot mount the Junos Pulse Gateway in a recessed position in
a two-post rack or cabinet.
Installing the Junos Pulse Gateway in a Rack on page 51
Mounting the Junos Pulse Gateway on Four Posts in a Rack or Cabinet on page 65
Follow these guidelines when installing the MAG2600 on a desk:
You can install the MAG2600 on a desk, table, or other level surface.
The device is shipped with the rubber feet attached. The rubber feet stabilize the device
on the desk.
You can install the device in a horizontal position only.
Installing the MAG2600 in the MAG-RK1U4 Tray on page 67
You can front-mount the MAG2600 in a MAG-RK1U4 tray. Mid-mounting or rear-mounting
is not required. Many types of racks are acceptable, including four-post (telco) racks,
enclosed cabinets, and open-frame racks.
Chapter 9: Installing the Junos Pulse Gateway
67