Table 28: Hard Drive Leds On The Mag6610 And Mag6611 Junos Pulse - Juniper Junos Pulse MAG2600 Hardware Manual

®
Junos Pulse Gateway Hardware Guide
Table 27: Component LEDs on the Junos Pulse Gateway (continued)
LED State Meaning
Power Green The device is receiving power and is
LED functioning normally.
Off The device is not receiving power
100
On the MAG6610 and MAG6611, the hard drive and RAID status LEDs are located on the
back panel. These LEDs are described in

Table 28: Hard Drive LEDs on the MAG6610 and MAG6611 Junos Pulse

Gateways
LED State
Activity Green
Off
RAID Solid red
Status
Blinking red
Off
An AC power supply has one bicolor LED on its faceplate. This LED displays information
about the status of the power supply.
Possible Causes and Corrective Actions
Normal condition. No action is required.
Normal condition if the Junos Pulse Gateway is switched
off. No action is required.
If you have not powered off the Junos Pulse Gateway, verify
that the AC power cord from the power source to the device
is not damaged, the socket is in working condition, and the
device has an AC input voltage between 110 and 240 VAC.
Table 28 on page
Possible Causes and Corrective
Meaning Actions
Activity No action is required.
No activity No action is required.
RAID drive has failed Replace the RAID hard drive. Contact
Juniper Networks Technical Support.
RAID activity No action is required.
RAID drive is functioning No action is required.
properly
100.
Copyright © 2014, Juniper Networks, Inc.