Repair And Inspection Required After Accident - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:
Table of Contents

Advertisement

Special tool
(A): 09932-76010 Connector test adapter kit
• Poor terminal-to-wire connection.
Check each wire harness in problem circuits for poor
connection by shaking it by hand lightly. If any
abnormal condition is found, change the wire harness
assembly or component parts with new ones.
• Wire insulation which is rubbed through, causing an
intermittent short as the bare area touches other
wiring or parts of the vehicle.
• Wire broken inside the insulation. This condition could
cause a continuity check to show a good circuit, but if
only 1 or 2 strands of a multi-strand-type wire are
intact, resistance could be far too high.

Repair and Inspection Required after Accident

• All air bag system components, including
• Never use air bag system parts from
• Do not attempt to service the parts below.
(A)
I4RS0A820045-01
• Proper operation of the sensors and air
After detecting one time of such collision as
IYSQ01010028-01
to meet deployment conditions, the SDM
must not be used.
Refer to "Air Bag Diagnostic System Check"
when checking the SDM.
Accident with Deployment / Activation – Component
Replacement
When driver and passenger air bags are deployed, the
following components must be replaced.
• Driver and passenger air bag (inflator) modules
• Driver and passenger seat belt pretensioners
• SDM
• Driver / Passenger forward-sensors
• Instrument panel
IYSQ01820025-01
CAUTION
!
the electrical harness (component
mounting points), must be inspected after
an accident. If any components are
damaged or bent, they must be replaced
even if air bag system activation did not
occur.
another vehicle.
Service of these parts is by replacement
only.
– Driver / Passenger air bag (inflator)
modules
– Driver / Passenger side-air bag (inflator)
modules
– Driver / Passenger side curtain-air bag
(inflator) modules
– Driver / Passenger seat belt
pretensioners
– Driver / Passenger forward-sensors
– Left / Right side-sensors
– SDM
– Contact coil
– Air bag wire harness in main harness,
instrument panel harness, floor harness,
passenger air bag harness and seat
harness.
bag system requires that any repairs to the
vehicle structure return it to its original
production configuration.
CAUTION
!
Air Bag System:
8B-94
S6JB0A8204041

Advertisement

Table of Contents
loading

Table of Contents