Flush Mount - Furuno SFD-1010 Operator's Manual

5. After installing the equipment to the hanger, tighten the supplied knob into the upper
knob-mounting hole.
5.1.3

Flush mount

This equipment can be mounted horizontally and vertically.
Read the contents of this section carefully and mount this equipment on a flat surface.
Improper mounting may cause failures with the display screen of this equipment.
Note: Check that the mounting surface is flat, even and without curve.
1. Make a mounting hole at mounting location by using the enclosed template for SFD-
1010 or SFD-1012.
2. Wing nut and wing bolt attached to flush mounting brackets (2 in total) to move the
protector part toward the brackets.
Knob
Flat
Curved
5. INSTALLATION
Knob
Uneven
5-3