Table of Contents
Advertisement
SAFETY INSTRUCTIONS
Safety Instructions on Installation
⚠WARNING
Be sure to turn off the power at the
switchboard before installing the
equipment.
Fire or electrical shock can result.
Make sure no water leaks in at the
transducer or water temperature
sensor mounting location.
Water leakage can sink the vessel. Install
the equipment carefully so that the
transducer and/or sensor will not come
off or drop off by ship's vibration.
The installer is responsible for the proper
installation of the equipment.
Use the specified power cable / data
cable.
Use of other power cable / data cable can
cause serious accident or fire.
iv
CAUTION
Do not install the transducer in a
place where air bubbles and noise are
present.
The equipment performance will be
affected.
The following are guidelines for
handling of the transducer cable.
· Keep on-board oils (lubricant, fuels)
away from the cable.
· Locate cable in a safe place to
avoid risk of damage during on-
board work.
· Do not paint the cable.
The cable may become corroded or
damaged, leading to malfunction.
The sheath of the transducer cable is
made of chloroprene rubber (or
polychloride vinyl), which can be
deteriorated by organic solvent (such as
toluene) contained in marine paint, etc.
Do not turn on the equipment with the
transducer out of water.
The transducer can be damaged.
Observe the following compass safe
distances.
Otherwise, the ship may not be steered
safely.
Advertisement
Table of Contents
Troubleshooting
