How To Adjust The Sweep Timing - Furuno SFD-1010 Operator's Manual

Key control:
1. Press the MENU/ESC key to open [MENU].
2. Select [SCANNER SETUP] with the arrow keys, then press the ENTER key.
3. Select [Heading Alignment] with the arrow keys, then press the ENTER key.
The cursor moves to the slider bar on the right side of the menu.
4. Set the heading line bearing with the arrow keys.
5. Press the MENU/ESC key to close [MENU].
5.7.2

How to adjust the sweep timing

Radar calculates a range to a target by measuring the time required from the moment
the transmitted echo reaches a target to the moment it is received by their radar antenna.
The received echo is displayed on the screen according to the measured time. The
sweep timing of the antenna unit differs depending on the length of the signal cable
between the control unit and the antenna unit. If sweep timing is not adjusted correctly,
the echo of from a "straight" target is not displayed straightly.
(1) Center area pulled
inward
Take the following steps to adjust the timing.
Touch control:
1. Press the MENU/ESC key to open [MENU].
2. Tap [SCANNER SETUP].
3. Tap [Timing Adjust].
The cursor moves to the slider bar on the right side of the menu.
4. Drag the slider bar or tap [+] or [-] to set the timing.
5. Tap [x] on the title bar to close [MENU].
Key control:
1. Press the MENU/ESC key to open [MENU].
2. Select [SCANNER SETUP] with the arrow keys, then press the ENTER key.
(2) Correct
5. INSTALLATION
(3) Center area
pushed outward
5-19