Replacing The Fuse; Troubleshooting; General Problems - Furuno SFD-1010 Operator's Manual

6. MAINTENANCE, TROUBLESHOOTING
6.2

Replacing the Fuse

If the equipment cannot be turned on, its fuse may have blown. The fuse (model: FGBO-A
250V 5A PBF, code No. 000-155-840-10) is located in the fuse box of the power cable.
Replace it with the proper fuse. If the fuse blows again after the replacement, contact your
dealer, agent or FURUNO's local branch or local sales office.
6.3

Troubleshooting

If you suspect a malfunction, check the following points first. Never attempt to open the
cover even when you cannot restore normal operation. In such case, contact your dealer,
agent or FURUNO's local branch or local sales office.
6.3.1

General problems

Problem
Power does not turn on.
Picture freezes.
No response to a touch control.
Proper picture is not displayed.
6-2
⚠
WARNING
Use the proper fuse.
Use of a wrong fuse can cause
a serious accident or fire.
 Check if the fuse has blown.
 Check if the power connector is tightly connected.
 Check for corrosion of power cable connector.
 Check for damage on the power cable.
 Check if onboard power voltage meets the rated voltage.
Press and hold the power key until the display is dimmed to
restart the system.
 Check if touch control locking is set to [OFF] in
[BRILLIANCE MENU].
 Turn the unit off and on. If normal operation is not
restored, contact your dealer or FURUNO's branch or
sales office.
 Reset the power. If proper picture is still not displayed,
contact a FURUNO agent or dealer for advice.
Remedy