Furuno SFD-1010 Operator's Manual page 200

5. INSTALLATION
Installation setting of the SCX-20/21
SCX-20/21 settings are available from the sensor switching screen. Tap SCX Settings at
the right upper corner of the screen to show the settings (refer to 5.12 SCX Setting).
Demo display
On the sensor selection screen, you can select a demo display of a fish finder, radar or
DFF-3D.
How to change the sensor
There are two ways to change the sensor to use as follows.
When using radar
Change from [MENU]
1. Select [MENU] → [INSTALLATION] → [Sensor Switching].
2. The pop-up window asks if you are sure to proceed. Select [YES].
Change from [BRILLIANCE]
1. Press POWER/BRILLIANCE key.
2. Select [Sensor Switching].
3. The pop-up window asks if you are sure to proceed. Select [YES].
5-16
5-16