How To Measure The Target Bearing; How To Measure The Bearing Using Electronic Bearing Lines (Ebl) - Furuno SFD-1010 Operator's Manual

2. RADAR
4. Select [NM], [km], [SM], [KYD] or [NM&YD] with the arrow keys, then press the
ENTER key.
5. Press the MENU/ESC key to close [MENU].

2.12 How to Measure the Target Bearing

The Electronic Bearing Lines (EBLs) are used to take bearings of targets. There are two
EBLs, EBL1 and EBL2. Each EBL is shown as a dashed line to differentiate itself from
the heading line. EBL1 and EBL2 can be distinguished from each other by the different
lengths of their dashes. The dashes on EBL2 are longer than those of the EBL1.
2.12.1 How to measure the bearing using Electronic Bearing Lines
(EBL)
1. Tap the [EBL1] box or the [EBL2] box, whichever you want to set, at the lower left of
the screen.
2. After the box starts flashing, drag the EBL shown on the screen.
3. Move the EBL onto the echo whose bearing you want to measure, then press the
ENTER key to confirm the location.
4. To erase the displayed EBL, tap the [EBL] box you have set.
EBL1 box
EBL2 box
2-20