Table of Contents
Advertisement
Manual
00809-0500-4880
2.3.10
Heater power connections
Use the blue, white, orange, black, red, and yellow stranded wires in the heater
power cable to connect power to the three heaters in the sensor housing.
Match the wire colors to the corresponding heater power terminal blocks in the
sensor and electronics housings as shown in
Figure 2-10: Line voltage, earth, and 4-20 mA connections
A. Alarm output relay terminal block
B. F
C. HART
D. Signal output terminal block
E. Ground stud
F. Earth ground typical for electronics and sensor housing
G. Ground
H. Customer wiring
I. Terminal block
J. EMI filter
K. External tooth locks washer
L. Signal port ¾-in. NPT
M. Power port ¾-in. NPT
2.4
Pneumatic installation
Pneumatic system connections depend on whether reference air set, calibration
solenoids, and/or blowback equipment options are equipped on your transmitter.
Rosemount OCX8800A
Fieldbus
™
OUNDATION
®
December 2022
Figure 2-7
and
Table
2-5.
Install
43
Advertisement
Table of Contents
