Table of Contents
Advertisement
Maintenance and service
December 2022
3. Remove tubes (B, C, and D) from the COe sensor assembly (I), eductor
4. Unfasten bayonet connector of COe thermocouple (L) and remove
5. Loosen clamp screw of COe band heater (M) until the heater rotates freely
6. See
256
fittings (N and H), and sensor housing (P).
thermocouple.
on the sensor holder.
Figure
10-11. Using a straight edge on the sensor holder flat, as shown,
matchmark the upper flange of sensor housing to show the correct
alignment of the sensor holder (J).
Figure 10-11: Alignment of COe Sensor Assembly
A. Matchmark
B. Straightedge
C. Sensor holder flat
Manual
00809-0500-4880
Emerson.com/Rosemount
Advertisement
Table of Contents
