Table of Contents
Advertisement
Manual
00809-0500-4880
5. Refer to
6. Install the sensor housing cover.
7. Restore power to the system. Allow the transmitter to reach normal
8. Insert and bolt the sensor housing in the stack and install insulation.
9. Turn on the test gases at the cylinders and open the instrument air supply
Remove remote electronics housing
Procedure
1. Turn off power to the system.
2. Shut off the test gases at the cylinders and close the instrument air supply
3. Disconnect the test gas and instrument air lines from the remote
4. Remove the cover from the electronics housing to expose the electronics
Rosemount OCX8800A
Figure 10-3
and make sure all test gas lines and electrical
connectors are complete.
operating temperature.
valve.
valve,
Figure
10-3.
electronics housing.
housing terminal blocks,
Figure
10-5.
Maintenance and service
December 2022
245
Advertisement
Table of Contents
