Connecting To The Network; To Connect To Copper Fast Ethernet Or Gigabit Ethernet Networks - Sun Microsystems StorageTek 5320 Getting Started Manual

2. Connect one Active Copper cable between the A side port 2 of expansion
enclosure 1 and the A side port 1 of expansion enclosure 2.
3. Continue to connect one Active Copper cable between the A side port 2 of each
expansion enclosure and the A side port 1 of the expansion enclosure directly
below it, until the A sides of all expansion enclosures are interconnected with
Active Copper cables.
4. Connect one Active Copper cable between the B side expansion port of the
controller enclosure and the B side port 2 of expansion enclosure 7.
5. Connect one Active Copper cable between the B side port 1 of expansion
enclosure 7 and the B side port 2 of expansion enclosure 6.
6. Continue to connect one Active Copper cable between the B side port 1 of each
expansion enclosure and the B side port 2 of the expansion enclosure directly
above it, until the B sides of all expansion enclosures are interconnected with
Active Copper cables.
Note – The A side port 2 of expansion enclosure 7 and the B side port 1 of
expansion enclosure 1 remain empty.

Connecting to the Network

Use the following procedures to connect the Sun StorageTek 5320 NAS Appliance to
the network. The available network connectors depend on your system
configuration: Fast Ethernet or optical Gigabit Ethernet. Each configuration is
described in the following sections.
To Connect to Copper Fast Ethernet or Gigabit
▼
Ethernet Networks
Refer to
FIGURE 3-10
1. To connect the Sun StorageTek 5320 NAS Appliance to a 100BASE-T Fast Ethernet
network or to a 1000BASE-T Gigabit Ethernet network, connect an RJ-45
unshielded twisted-pair cable from your local area network (LAN) to port NET0
on the back of the Sun StorageTek 5320 NAS Appliance.
for NIC port locations.
Chapter 3 Connecting the Sun StorageTek 5320 NAS Appliance 65