To Cable A Controller Enclosure To Two Expansion Enclosures; Figure 3-7 Controller Enclosure And Two Expansion Enclosures Cable Interconnection - Sun Microsystems StorageTek 5320 Getting Started Manual

▼
To Cable a Controller Enclosure to Two Expansion
Enclosures
To connect a controller enclosure and two expansion enclosures, four 2-meter Active
Copper cables are required. Refer to
Controller Enclosure and Two Expansion Enclosures Cable Interconnection
FIGURE 3-7
Caution – Do not mix EU F (Fibre Channel) and EU S (SATA) expansion enclosures
attached to a controller enclosure.
1. Connect one Active Copper cable between the A side expansion port of the
controller enclosure and the A side port 1 of expansion enclosure 1.
2. Connect one Active Copper cable between the A side port 2 of expansion
enclosure 1 and the A side port 1 of expansion enclosure 2.
3. Connect one Active Copper cable between the B side expansion port of the
controller enclosure and the B side port 2 of expansion enclosure 2.
4. Connect one Active Copper cable between the B side port 1 of expansion
enclosure 2 and the B side port 2 of expansion enclosure 1.
Note – The A side port 2 of expansion enclosure 2 and the B side port 1 of
expansion enclosure 1 remain empty.
FIGURE 3-7
A
Chapter 3 Connecting the Sun StorageTek 5320 NAS Appliance
.
B
Controller enclosure
Expansion enclosure 1
Expansion enclosure 2
61