Table of Contents
Advertisement
2. Select A. Network Config.
3. Select A. Set Gateway and enter the gateway address.
To enter data, use the up and down arrow buttons to select digits, dots, or spaces.
Then use the ENTER or right arrow button to accept each character.
4. Select C. Set Port-emx1 or C. Set Port-emx2 (depending on which port is the first
regular LAN port) and enter the IP address, subnet mask, and broadcast address as
prompted.
This IP address information is assigned to the first regular LAN port on your
system.
5. Select Escape twice to return to the main menu.
Configuring the Single-Server System
To configure the system, you must set up basic system configuration and activate the
license for the server.
Note – You must perform both tasks before proceeding to
Configuration" on page
▼
To Set Up Basic Configuration
1. From a client on the same network, open a Java platform-enabled web browser
with Java Plug-in and enter the IP address for the server.
2. Accept the "Applet Security Certificate" and wait until the Web Admin applet is
loaded on this system.
3. On the Web Admin login screen, click Apply.
The password can be set later. Refer to the Sun StorageTek 5320 NAS Appliance and
Gateway System Administration Guide.
4. On the Set Time and Date panel, select the date, the time, and the time zone, and
click Apply. Then click Yes to confirm.
This sets the secure clock to the same time and date. Make sure you set the time and
date accurately as you can set the secure clock only once.
5. Read the license agreement in the Configuration wizard dialog box, and click
Accept to proceed with the following wizard steps:
a. Click Next in the Welcome dialog box.
164
Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
175.
"SAN Storage
Advertisement
Table of Contents
