Table of Contents
Advertisement
▼
To Configure Storage on the Sun StorageTek 5320 NAS
Gateway System Single Server
1. Reboot the Sun StorageTek 5320 NAS Gateway System server so that it can detect
the storage.
You can reboot using Web Admin or the LCD panel.
To use Web Admin to reboot:
a. In the navigation panel, select System Operations > Shut Down the Server.
b. Select Reboot This Head, and click Apply.
To use the LCD panel to reboot:
a. On the server's LCD panel, select B. Shutdown Server from the menu.
b. Select B. Reboot. The LCD displays "Are you sure? No." Press the up arrow
button to change to "Yes." Then press the ENTER or the right arrow button to
reboot.
2. After the server has rebooted, use Web Admin to configure file volumes.
Refer to the Sun StorageTek 5320 NAS Appliance and Gateway System Administration
Guide.
Initial Sun StorageTek 5320 NAS
Gateway Cluster System Configuration
Note – These instructions apply to the Sun StorageTek 5320 NAS Gateway Cluster
System configuration only. For Sun StorageTek 5320 NAS Gateway System
configuration instructions, refer to
System Single-Server Configuration" on page
Cluster Appliance configuration instructions, refer to
To complete the initial Sun StorageTek 5320 NAS Gateway Cluster System
configuration, you must specify the following:
IP addresses
■
Basic system configuration
■
Storage and LUN configuration
■
Failover configuration
■
LUN paths
■
"Initial Sun StorageTek 5320 NAS Gateway
Chapter 5 Installing the Sun StorageTek 5320 NAS Gateway System
163. For Sun StorageTek 5320 NAS
Chapter
4.
167
Advertisement
Table of Contents
