Table of Contents
Advertisement
6. When you have logged in to Web Admin, on the main System Status window,
check the Features Enabled to be sure that "Sun StorageTek NAS Gateway"
appears.
7. In the navigation panel, select RAID > View HBA Information to view the port
World Wide Names (WWNs) of the HBA ports.
The port WWNs are used to map the LUNs on the SAN storage device or to zone
these ports on the fabric switch.
Each HBA port is delineated by a tab at the top of the window. HBA port numbering
refers to the physical HBA ports from right to left and bottom to top. Refer to
,
"HBA Port Numbering" on page
TABLE 5-1
For each HBA port, the port WWN is listed in the upper portion of the window. The
port WWNs are used to map the LUNs on the SAN storage device or to zone these
ports on the fabric switch.
8. Write down the port WWNs of all the HBA ports.
WWNs consist of 16 characters that start after the "x" and do not include the "."
9. Log out of Web Admin and close the browser.
▼
To Set Up Server H2
1. Assign server H2's IP address and gateway address using the instructions in
Set IP Addresses" on page
2. Set up server H2's basic configuration using the instructions in
Configuration" on page
3. Activate server H2's license using the instructions
NAS Gateway License" on page
▼
To Configure SAN Storage on the Sun StorageTek 5320 NAS
Gateway Cluster System
1. Configure SAN storage using the appropriate instructions:
"Sun StorEdge 6130 Array" on page 175
■
"To Configure Storage on the Sun StorEdge 6920 System" on page 178
■
"To Configure Storage on the Sun StorEdge 99xx System" on page 179
■
2. Configure storage on the Sun StorageTek 5320 NAS Gateway Cluster System,
using the instructions in the next section.
168.
169.
170.
Chapter 5 Installing the Sun StorageTek 5320 NAS Gateway System
166.
"To Activate the Sun StorageTek
"To
"To Set Up Basic
171
Advertisement
Table of Contents
