Table of Contents
Advertisement
FIGURE 4-6
Caution – Do not mix EU F (Fibre Channel) and EU S (SATA) expansion enclosures
attached to a controller enclosure.
1. Connect one Active Copper cable between the A side expansion port of the
controller enclosure and the A side port 1 of expansion enclosure 1.
2. Connect one Active Copper cable between the A side port 2 of expansion
enclosure 1 and the A side port 1 of expansion enclosure 2.
3. Connect one Active Copper cable between the B side expansion port of the
controller enclosure and the B side port 2 of expansion enclosure 2.
4. Connect one Active Copper cable between the B side port 1 of expansion
enclosure 2 and the B side port 2 of expansion enclosure 1.
Note – The A side port 2 of expansion enclosure 2 and the B side port 1 of
expansion enclosure 1 remain empty.
▼
To Cable a Controller Enclosure to Three Expansion
Enclosures
To connect a controller enclosure and three expansion enclosures, six 2-meter Active
Copper cables are required. Refer to
84
Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
A
Controller Enclosure and Two Expansion Enclosures Cable Interconnection
B
.
FIGURE 4-7
Controller enclosure
Expansion enclosure 1
Expansion enclosure 2
Advertisement
Table of Contents
