To Cable A Controller Enclosure To One Expansion Enclosure; Figure 3-6 Controller Enclosure And One Expansion Enclosure Cable Interconnection - Sun Microsystems StorageTek 5320 Getting Started Manual

The cabling differs depending on the number of expansion enclosures you are
connecting:
For one expansion enclosure, refer to
■
Expansion Enclosure" on page
For two expansion enclosures, refer to
■
Expansion Enclosures" on page
For three expansion enclosures, refer to
■
Expansion Enclosures" on page
For four to seven expansion enclosures, refer to
■
to Seven Expansion Enclosures" on page
▼
To Cable a Controller Enclosure to One Expansion
Enclosure
To connect a controller enclosure and one expansion enclosure, two 2-meter Active
Copper cables are required. Refer to
FIGURE 3-6
1. Connect one Active Copper cable between the A side expansion port of the
controller enclosure and the A side port 1 of the expansion enclosure.
2. Connect one Active Copper cable between the B side expansion port of the
controller enclosure and the B side port 2 of the expansion enclosure.
Note – The A side port 2 and B side port 1 of the expansion enclosure remain
empty.
60 Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
A
Controller Enclosure and One Expansion Enclosure Cable Interconnection
"To Cable a Controller Enclosure to One
60.
"To Cable a Controller Enclosure to Two
61.
"To Cable a Controller Enclosure to Three
62.
"To Cable a Controller Enclosure
64.
.
FIGURE 3-6
B
Controller enclosure
Expansion enclosure