Table of Contents
Advertisement
Note – If you would like to verify your settings on the LCD panel, HB Port shows a
private IP address, and Port emc2 (the first regular LAN port) shows the information
you just entered.
You can edit the port information and assign addresses to other ports in the same
way.
6. From server H1's LCD menu, select C. Take All LUNs and press the ENTER
button.
7. When prompted to "take all LUNs," press the up arrow button to select "Yes," and
press the ENTER or right arrow button to start taking LUNs.
The LCD displays "Taking LUNs" followed by a message "Took n LUNs." After a
few seconds, the display returns to the Network Config menu.
8. Select Escape to return to the main menu.
Server H1 is now in the ALONE state.
9. Power on the server H2 (software serial number ending in "-H2") by pressing the
recessed Power button.
10. Wait until server H2's LCD display status is QUIET.
11. Use the instructions in
gateway address.
▼
To Configure the System
To configure the system using the Web Admin application, follow these instructions:
1. From a client on the same network, open a Java platform-enabled web browser
with Java Plug-in and enter the IP address for server H1.
2. Accept the "Applet Security Certificate" and wait until the Web Admin applet is
loaded on this system.
3. On the Web Admin login screen, click Apply.
The password can be set later. Refer to the Sun StorageTek 5320 NAS Appliance and
Gateway System Administration Guide.
4. On the Set Time and Date panel, select the date, the time, and the time zone, and
click Apply. Then click Yes to confirm.
This sets the secure clock to the same time and date. Make sure you set the time and
date accurately as you can set the secure clock only once.
94
Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
Step 1
through
Step 5
to assign server H2's IP address and
Advertisement
Table of Contents
