"Powering On the Sun StorageTek 5320 NAS Gateway System" on page 161
■
"Initial Sun StorageTek 5320 NAS Gateway System Single-Server Configuration"
■
on page 163
"Initial Sun StorageTek 5320 NAS Gateway Cluster System Configuration" on
■
page 167
"SAN Storage Configuration" on page 175
■
Note – The Sun StorageTek 5320 NAS Gateway System and Sun StorageTek 5320
NAS Gateway Cluster System ship with the operating system installed.
Before You Begin
Before connecting the system, do the following:
If desired, install the Sun StorageTek 5320 NAS Gateway System or Sun
■
StorageTek 5320 NAS Gateway Cluster System and switch or switches, if used, in
a cabinet. Follow the installation instructions in Chapter 2 for
in a Cabinet" on page
Set up the SAN storage devices, referring, if necessary, to your SAN storage
■
documentation.
You will configure storage after the Sun StorageTek 5320 NAS Gateway System is
installed and set up.
Installation and Configuration Task
Overview
To set up the Sun StorageTek 5320 NAS Gateway System, you perform the following
tasks:
1. Connect to SAN storage.
Refer to the instructions for your SAN storage:
"Connecting the Sun StorageTek 5320 NAS Gateway System to the Sun StorEdge
■
6130 Array" on page 102
"Connecting the Sun StorageTek 5320 NAS Gateway System to the Sun
■
StorageTek FlexLine 200 and 300 Series" on page 114
100
Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
33.
"Installing a Server