Figure 2-28 Tray Id Switch - Sun Microsystems StorageTek 5320 Getting Started Manual

1. Locate the Tray ID switch at the back of the controller enclosure, between the two
power supplies (
FIGURE 2-28
2. Use a pen tip to press the plus and minus buttons on the X10 and X1 switch to the
appropriate setting.
The X10 switch at the left sets the tens place of the tray ID, and the X1 switch sets the
ones place. For example, to set the tray ID to 11, set the X10 switch to 1 and the X1
switch to 1.
By convention, tray ID 00 refers to the controller enclosure. The first expansion
enclosure located above the controller enclosure is tray ID 01. The second expansion
enclosure is tray ID 02. The tray ID increments by 01 for each expansion enclosure
installed in the cabinet.
50 Sun StorageTek 5320 NAS Appliance and Gateway System Getting Started Guide • May 2006
).
FIGURE 2-28
Tray ID Switch
Tray ID switch