Table of Contents
Advertisement
2. Connect the HBA port 1 of the second HBA card to the Controller B host 1 port.
Sun StorageTek 5320 NAS Appliance
5300 RAID controller enclosure
Connecting Two HBA Cards
FIGURE 3-3
Note – The host 2 port on the controller A and controller B remain empty.
▼
To Connect Two Controller Enclosures
Use the instructions in this section and refer to
controller enclosures to the Sun StorageTek 5320 NAS Appliance.
Note – The Sun StorageTek 5320 NAS Appliance must have two HBA cards to
connect to two controller enclosures.
Caution – One array can contain Fibre Channel disk drives in the controller
enclosure and expansion enclosures, and the other array can contain SATA disk
drives in the expansion enclosures only. However, you cannot mix EU F (Fibre
Channel) and EU S (SATA) expansion enclosures attached to a controller enclosure.
1. Connect the HBA port 1 of the first HBA card to the Controller A host 1 port on
the second controller enclosure.
Controller A
to the Controller Enclosure
Chapter 3 Connecting the Sun StorageTek 5320 NAS Appliance
Controller B
if you are connecting two
FIGURE 3-4
57
Advertisement
Table of Contents
