Table of Contents
Advertisement
b. From the Select Environment screen, configure Windows, UNIX, or both
environments, and click Next to continue.
c. From the Set Server Name screen, type the server name and populate the other
fields accordingly, and then click Next.
d. On the Configure Network Adapters screen, verify that the information is
correct, and click Next to continue.
You can configure additional network interfaces at this time. However, if you
change the configuration of the port to which the browser is attached, the browser
session is disconnected.
e. On the Set Gateway Address screen, verify that the address is correct, and, if
not, type the gateway address. Click Next to continue.
f. For all the other wizard configuration steps, refer to the Sun StorageTek 5320
NAS Appliance and Gateway System Administration Guide for more
information.
Note – When adding your DNS server, click Add to ensure that the DNS server has
been added.
g. In the Confirmation screen, review the configuration information you have
added.
Note – Be sure the configuration information is accurate before continuing.
h. Click Finish on the wizard Confirmation screen.
The system configures the settings and indicates that in the Save Configuration
screen. It also displays a message that both servers must reboot for the failover
changes to be applied.
i. Click Close on the Save Configuration screen.
▼
To Activate the Sun StorageTek NAS Gateway License
1. In the navigation panel, select System Operations > Activate Options.
2. Click the Temporary Licenses button.
3. Select Sun StorageTek NAS Gateway, and click Apply.
The State displays "valid" and the Status displays "active."
4. Log out of Web Admin, and close all browser instances.
Chapter 5 Installing the Sun StorageTek 5320 NAS Gateway System
165
Advertisement
Table of Contents
