Table of Contents
Advertisement
Note – Verify that both servers are in the NORMAL state on the LCD Panel display
or on the Web Admin main page, where the Head Status and Partner Status should
display NORMAL.
To Assign LUN Paths
▼
You should assign LUN paths on each server to balance multipath access from each
server to each storage controller. You can automatically assign LUN paths using the
CLI Auto-assign LUN paths option on the LUN Paths screen, or you can use the Web
Admin, as follows:
1. In the Web Admin navigation panel, select High Availability > Set LUN Path.
2. Select a LUN and click Edit.
3. Select the desired controller from the Primary Path drop-down menu.
Evenly divide the assignment of LUNs to the two available paths. For example, the
first and third LUN to 1/0 and the second and fourth LUN to 1/1.
4. Click Apply.
Refer to the Sun StorageTek 5320 NAS Appliance and Gateway System Administration
Guide for additional information about LUNs and other detailed software setup and
use.
To Configure the Partner
▼
For server H2, repeat all steps in
following exceptions:
In
Step 6
d. in
■
the partner H1 server.
As you complete the configuration process, there is no message to reboot the
■
servers, since you do not need to reboot the servers
"To Configure the System" on page 94
"To Configure the System" on page
Chapter 4 Installing the Sun StorageTek 5320 NAS Cluster Appliance
with the
94, enter the information for
97
Advertisement
Table of Contents
