Table of Contents
Advertisement
Basic Dual-Server System Configuration
To configure the system, you must set up basic system configuration and activate the
license for server H1, and then repeat the steps for server H2.
Note – You must perform all basic system configuration tasks on both servers
before proceeding to
▼
To Set Up Basic Configuration
1. From a client on the same network, open a Java platform-enabled web browser
with Java Plug-in and type the IP address for server H1.
2. Accept the "Applet Security Certificate" and wait until the Web Admin applet is
loaded on this system.
3. On the Web Admin login screen, click Apply.
The password can be set later. Refer to the Sun StorageTek 5320 NAS Appliance and
Gateway System Administration Guide.
4. On the Set Time and Date panel, select the date, the time, and the time zone, and
click Apply. Then click Yes to confirm.
This sets the secure clock to the same time and date. Make sure you set the time and
date accurately as you can set the secure clock only once.
5. Read the license agreement in the Configuration wizard dialog box, and click
Accept to proceed with the following wizard steps:
a. Click Next in the Welcome dialog box.
b. From the Select Environment screen, configure Windows, UNIX, or both
environments. Click Next to continue.
You can add additional configuration information later.
c. From the Set Server Name screen, type the server name and populate the other
fields accordingly, and then click Next.
d. On the Enable Failover screen, skip the screen by clicking Next.
Caution – Do not enable failover at this time. Storage must be configured before
failover can be enabled.
In the partner configuration part of the screen, the system initially sets default
server names head1 and head2. You can change these defaults later when you
configure failover (see
"To Configure LUN Paths" on page
"To Configure Failover" on page
Chapter 5 Installing the Sun StorageTek 5320 NAS Gateway System
174.
172).
169
Advertisement
Table of Contents
