Connect An Acx5400 Router To A Network For Out-Of-Band Management - Juniper ACX5448-D Hardware Manual

Figure 68: Connecting the ACX5400 Router to a Management Console Through a Console Server
CON
To Console Port
Figure 69: Connecting the ACX5400 Router Directly to a Management Console
CON
ETH CRAFT
port (on device)

Connect an ACX5400 Router to a Network for Out-of-Band Management

You can monitor and manage the ACX5400 router by using a dedicated management channel. ACX5400
routers have a minimum of two management ports: a 10/100/1000BASE-T RJ-45 port and a 1-Gbps SFP
port. Some models have an additional 1-Gbps SFP port that can be used for either fiber or copper
connections. Use the management ports to connect the ACX5400 router to a network for out-of-band
management.
CAUTION:
NOTE: You cannot use the management ports to perform the initial configuration of the ACX5400
router. You must configure the management ports before you can successfully connect to the
ACX5400 router using these ports. See
ACX5448-D, and ACX5448-M Routers" on page
Ensure that you have an appropriate cable available. See
Cable and Transceiver Planning" on page
To connect a ACX5400 router to a network for out-of-band management (see
1. Connect one end of the cable to one of the management ports (labeled MGMT on the ACX5400 router.
Laptop CPU
Laptop CPU
Do not configure the two management interfaces within the same subnet.
"Perform Initial Software Configuration for the ACX5448,
73.
109.
"ACX5448, ACX5448-D, and ACX5448-M Network
Figure 70 on page 108):
107