Panasonic WH-ADF0309J3E5CM Service Manual page 155

■ RC. setting mode
1 Press and hold the 3 buttons for
4 seconds or more simultaneously.
, , ►
2 Select the item to set.
▲ ▼ →
RC. setting mode
3 Set.
(Select the Code no. and Set data.)
▲ ▼ → ► →
(Repeat)
4
Press
● After Selecting [YES], the unit restarts.
Code no.
01 Main/sub
02 Clock type
2F Password change
Display of operation lock
36
cancelling method
Detailed settings
3 Set.
(Select the indoor unit number, Code no.
and Set data.)
▲ ▼ → ► →
(Repeat)
4
Press
● After Selecting [YES], the unit restarts.
Code no.
31 Vent output setting
32 Temp sensor setting
33 Temp display setting
■ Detailed settings
Set this when using 2 remote controllers.
Set the type of clock display.
Set the administrator password.
Set whether to display the operation lock cancelling
method on the lock screen while operation is locked.
(For the lock screen, see the "Part Names" section
in the Operating Instructions.)
Set this when connecting a commercially sold fan,
etc. to the ventilation fan output "FAN DRIVE:2P
(White)" on the indoor control board.
*Dedicated cables (optional) are required.
Set this when measuring the room temperature with
the room temperature sensor of the remote
controller.
● When using the main and sub controllers, the
main one is enabled.
● When using with the remote sensor in
combination, set the indoor unit setting data.
● This setting is not available during group-
controlling.
Set the type of temperature display.
■ Auto address ■ Set elec. consumption
Code no. Set data
Indoor unit
number
Code no.
155
Set data
● 0000: Sub
● 0001: Main (factory setting)
● 0000: 24 hours
● 0001: 12 hours (AM/PM)
● 0000 to 9999
● 0000 (factory setting)
● 0000: Displayed (factory setting)
● 0001: Not displayed
● 0002: Not displayed (password)
Set data
Set data
● 0000: Not connected
● 0001: Connected
● 0000: Indoor unit
● 0001: Remote controller
● 0000: °C
● 0001: °F