Panasonic WH-ADF0309J3E5CM Service Manual page 14

Item
Protection Device
Volume
Expansion Vessel
MWP
Capacity of Integrated Electric Heater / OLP TEMP
Tank Volume (Spec / Nett)
Max. Tank Water Set Temperature
Tank Coil Surface
Space Heat
Maximum Working
Pressure
Tank Circuit
Tank Unit
Operating Pressure
Expansion Relief Valve
Expansion Vessel Pre-charge Pressure (DHW Circuit)
Pressure Reducing Valve Set Pressure (DHW Circuit)
Item
Pressure Vessel
Heat Exchanger
Note:

In case it is necessary to indicate the air flow volume in (I/s), the value in (m
rounded down the decimal point.

If the EUROVENT Certified models can be operated under the "extra-low" temperature condition, -7°C DB and
-8°C WB temperature with rated voltage 230V shall be used.

Capacity is measured at outdoor temperature 7°C DB and 6°C WB with controlled water inlet 30°C and water
outlet 35°C (EN 14511-2)

Flowrate indicated are based on nominal capacity adjustment of leaving water temperature (LWT) 35°C and
∆T=5°C.

EER and COP classification is at 230V only in occordance with EU directive 2003/32/EC.

* Above 55°C, only possible with backup heater operation.
Material
Volume
Design Pressure
Material
Diameter
Thickness
Surface Area
Total Length
Unit
A Earth Leakage Circuit Breaker (30 ~ 40)
I
bar
kW / °C
L
°C
m 2
Bar
Bar
Bar
Bar
Bar
Bar
Unit
L
Bar
mm
mm
2
m
m
14
WH-ADC0309J3E5CM
10
3
3.00 / 80
200 / 185
65
1.8
3.0
8.0
3.5
8.0
3.5
3.5
Indoor Unit
En-1.4521
185
10
EN-1.4521
22
0.8
1.8
25
3
/min.) shall be multiplied by 16.7 and