Panasonic WH-ADF0309J3E5CM Service Manual page 121

12.1.8.5 Auto Address Setting Using the Remote Controller
Auto Address Setting from the High-spec Wired Remote Controller (CZ-RTC5B)
(1) Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the
LCD display.
(2) Press the or
If you wish to see the next screen instantly, press
the or button.
Select "9. Auto address" on the LCD display and
press the button.
(3) The "Auto address" screen appears on the LCD
display.
Change the "Code no." to "A1" by pressing the
or button.
Auto Address Setting* from the Remote Controller (CZ-RTC4)
* Auto address setting in Cooling mode cannot be done from the remote controller.

Selecting each refrigerant system individually for auto address setting

Auto address setting for each system : Item code "A1"
(1) Press the remote controller timer time
and button at the same time.
(Press and hold for 4 seconds or longer.)
(2) Next, press either the temperature setting
button.
(Check that the item code is "A1".)
(3) Use either the
perform auto address setting.
(4) Then press the
(Auto address setting for one refrigerant system
begins.)
(When auto address setting for one system is
completed, the system returns to normal stopped
status.)
<Approximately 10 minutes are required.>
(During auto address setting, "
displayed on the remote controller.
This message disappears when auto address setting is completed.)
(5) Repeat the same steps to perform auto address setting for each successive system.
, and buttons
button to see each menu.
20:30 (THU)
20:30 (THU)
button to set the system No. to
button.
" is
(4) Select the "O/D unit no." by pressing the
Select one of the "O/D unit no." for auto address
by pressing the
Approximately 10 minutes are required.
When auto address setting is completed, the units
return to normal stopped status.
button
/
121
20:30 (THU)
[ ]
START
button.
or
(2)
(1) (4)
CZ-RTC5B
or
button.
(4)
(3)
CZ-RTC4