Panasonic WH-ADF0309J3E5CM Service Manual page 132

The fan motor will be activated, the auto external
static pressure setting operation and setting-check
operation will be performed for about 3 to 30
minutes. The fan speed will change automatically
while these operations are in progress. When
these operations completed, "TEST" will be
disappeared from the LCD display.
NOTE:
The auto external static pressure setting operation
and setting-check operation will not be performed
unless " (MODE FAN)" and "
SPEED)" have been selected.
11. Press the button.
The LCD display will be returned to the initial
screen.
[ ]
START
NOTE:
Failure to set this parameter may result in
decreased airflow and condensation.
12.1.10.3 Operating the Timer Remote
Controller (CZ-RTC4)
12.1.10.3.1 Setting Item Code "
1. Press and hold down the
buttons simultaneously for 4 or more seconds.
( , the unit no., item code and detailed
data will blink on the LCD display.)
2. The indoor unit numbers in the group control will
be sequentially displayed whenever the Unit
Select button is pressed
Only the fan motor for the selected indoor unit will
operate during this time.
20:30 (THU)
(FAN
20:30 (THU)
"
, and
.
3. Specify the "
buttons for the temperature setting buttons
and confirm the values.
(" " set at shipment)
4. Press the
amend the values for the set data.
See Table 10-3 and Page 303 and select a value
between "
Select "
is activated.
5. Press the
The display will stop blinking and remain
illuminated.
6. Press the
operating and the LCD display will return to the
normal stop mode.
Table 10-3 Setting the external static pressure
Indoor unit type
S-71WF3E
Outdoor unit type
CU-2WZ71YBE5
External static pressure of the rated
airflow volume (Pa)
150
140
130
120
110
90
70
50
30 *
10
No auto airflow volume setting
Auto airflow volume setting
* Setting at shipment
132
" item code by pressing the
/ buttons for the time to
" and " ".
" if the auto airflow volume setting
button.
button. The fan motor will stop
Item code
/