Panasonic WH-ADF0309J3E5CM Service Manual page 147

2. Mount to the wall.

Exposed type
① Make 2 holes for screws using a driver.
② Mount the bottom case to the wall.
③ Cut here with a nipper and remote the burr with a file.
④ Remove the sheath. Approx. 150 mm
⑤ Remove the coating. Approx. 6 mm
⑥ Connect the remote control wiring.

Make sure the wiring connection is in the correct direction.

Arrange the wires along the groove of the case.

Avoid the wire being caught.
⑦ Mount the top case.

Align the claws of the top case and then align the claws of the bottom case.

Embedded type
① Make 2 holes for screws using a driver.
② Mount the bottom case to the wall.

Pass the wire through the hole in the centre of the bottom case.
③ Remove the sheath. Approx. 50 mm
④ Remove the coating. Approx. 6 mm
⑤ Connect the remote control wiring.

Make sure the wiring connection is in the correct direction.

Avoid the wire being caught.
⑥ Mount the top case.

Align the claws of the top case and then align the claws of the bottom case.
Claw
(2 places)
Hole for
screw
Claw (2 places)
Screw
(supplied)
Claw
(2 places)
Hole for
screw
Claw (2 places)
Screw
(supplied)
147
Top case
Bottom case
(Back side)
(Back side)
Terminal board
150 mm
6 mm
Top case
(Back side)
Bottom case
(Back side)
Terminal board
50 mm
6 mm