BMW 2 Series Owner's Handbook Manual page 301

What to do in the event of a flat tyre, see
page 302.
Messages: for tyres with special
approval
General
When a low tyre pressure is indicated, the Dy-
namic Stability Control may be turned on.
Safety information
WARNING
A damaged standard tyre with too little or no
tyre inflation pressure impairs driving charac-
teristics, for example steering and braking.
Tyres with run-flat capabilities allow a limited
level of stability to be maintained. There is a
risk of accident. Do not continue driving if the
vehicle is fitted with standard tyres. Comply
with the notes on run-flat tyres and continu-
ing driving with these tyres.
If a tyre inflation pressure check is
required
Message
An icon with a Check Control message is
shown on the control display.
Online Edition for Part no. 01405A5E758 - VI/22
Wheels and tyres
Icon Possible cause
The tyre was not inflated properly,
for example insufficient air was
added.
The system has detected a wheel
change, but no reset has been per-
formed.
The tyre inflation pressure has
dropped compared to the last reset.
No reset has been performed on
the system. System warning is
based on the tyre inflation pres-
sures saved during the last reset.
Measure
1. Check the tyre inflation pressure and adjust
as necessary.
2. Perform a system reset.
If the tyre inflation pressure is too low
Message
A yellow warning light is illuminated in
the instrument cluster.
In addition, an icon with a Check Control mes-
sage is shown on the control display.
Icon Possible cause
There has been a tyre pressure loss.
No reset has been performed on the
system. System warning is based
on the tyre inflation pressures saved
during the last reset.
Measure
1. Reduce speed. Do not exceed a speed of
130 km/h, 80 mph.
2. At the next opportunity, for example at a
filling station, check the tyre inflation pres-
MOBILITY
301