BMW 2 Series Owner's Handbook Manual page 209

The speed can also be stored by pressing the
button.
Press the key.
Changing the speed
Press the rocker switch repeatedly up or down
until the set speed is set.
If the system is active, the displayed speed is
stored and the vehicle adjusts to the stored
speed when the road is clear.
▷ Each time the rocker switch is tapped to the
resistance point, the set speed is increased
or decreased by 1 km/h, 1 mph.
▷ Each time the rocker switch is pressed past
the resistance point, the set speed changes
by 10 in the km/h display or 5 in the mph
display in the speedometer.
To repeat an action, hold the rocker switch in
the relevant position.
Adjusting the distance
Safety information
WARNING
The system does not relieve you of your per-
sonal responsibility. System limits may mean
that deceleration is performed too late. There
is a risk of accident or material damage. Pay
close attention to the traffic situation at all
times. Adapt the distance to suit traffic and
Driver assistance systems
Online Edition for Part no. 01405A5E758 - VI/22
weather conditions and comply with the pre-
scribed safe distance by braking if necessary.
Reducing the distance
Press the button repeatedly until the
desired distance is set.
The selected distance is displayed in the in-
strument cluster.
Increasing the distance
Press the button repeatedly until the
desired distance is set.
The selected distance is displayed in the in-
strument cluster.
Resuming Cruise Control
If Cruise Control is interrupted, it can be re-
sumed by calling up the stored speed.
Before calling up the stored speed, make sure
that the difference between the current speed
and the stored speed is not too great. Other-
wise, there may be unintentional deceleration
or acceleration.
If the system has been interrupted,
press the button on the steering wheel.
Cruise Control is resumed with the stored val-
ues.
In the following instances, the stored speed
value is deleted and therefore cannot be called
up again:
▷ When the system is switched off.
▷ When drive-ready state is switched off.
CONTROLS
209