BMW 2 Series Owner's Handbook Manual page 201

System limits
System limits of the sensors
For further information:
▷ Camera, see page 41.
Functional limitations
Functionality may be restricted or incorrect in-
formation may be displayed in some situations
such as:
▷ Road signs are fully or partially concealed
by objects, stickers or paint.
▷ Road signs do not correspond to the stand-
ard.
▷ In areas that are not included in the map
data of the navigation system.
▷ In the event of invalid, outdated or unavail-
able map data of the navigation system.
▷ If there are navigation discrepancies, for ex-
ample due to changes in road layout.
▷ If the vehicle is too close to the vehicle
ahead.
▷ When overtaking buses or trucks with road
sign stickers.
▷ If there are electronic road signs.
▷ If road signs are detected that apply to a
parallel road.
▷ If the road signs or road layouts are specific
to one country.
Manual Speed Limiter
Principle
The Manual Speed Limiter can be used to set
a speed limit, for instance, to prevent the vehi-
cle from exceeding speed limits.
General
The system allows speeds of 30 km/h/20 mph
and above to be set as a speed limit. Below
Driver assistance systems
Online Edition for Part no. 01405A5E758 - VI/22
the set speed limit, the vehicle can be driven
without restriction.
Overview
Buttons on the steering wheel
Button Function
System on/off.
To store the current speed.
Speed Limit Assist: to accept the
suggested speed manually.
Rocker switch:
To change the speed limit.
Operation
Switching on the speed limiter
Press the button on the steering wheel.
The current speed is adopted as the speed
limit.
When switching on at a standstill or driving
at low speed, 30 km/h/20 mph is set as the
speed limit.
The speedometer marker is set to the appro-
priate speed.
When switching on the speed limit, Dynamic
Stability Control may be switched on and the
drive mode switched to COMFORT.
Switching off off the speed limiter
Press the button on the steering wheel.
The system switches off automatically in situa-
tions such as the following:
CONTROLS
201