BMW 2 Series Owner's Handbook Manual page 248

CONTROLS
Preselection of departure time is done in two
stages:
▷ Set the departure times.
▷ Activate the departure time.
The system is automatically activated a few
minutes before the set departure time. The
system remains switched on until just after the
set departure time.
For safety reasons, climate control for depar-
ture time is only possible once.
The system will be available again once the
drive-ready state has been activated and de-
activated again.
Observe the information regarding the inten-
ded use of the vehicle.
For further information:
Your own safety, see page 9.
Setting the departure time
1. "CLIMATE MENU"
2. "Settings"
3. "Pre-conditioning"
4. "Departure plan"
5. Set the departure time.
6. Select the day of the week if necessary.
Activating the departure time
1. "CLIMATE MENU"
2. "Settings"
3. "Pre-conditioning"
4. "Departure plan"
5. Activate the required departure time.
Display
In the instrument cluster:
The engine runs for the purpose
of operating the pre-condition-
ing. The vehicle is not ready to
drive.
248
Air conditioning
Online Edition for Part no. 01405A5E758 - VI/22
Icon Description
Icon in the upper centre
console.
Icon is illuminated: heating
mode is turned on.
Icon in the upper centre
console.
Icon is illuminated: a de-
parture time is activated.
Icon flashes: the pre-condi-
tioning is turned on.
Vehicle acknowledgement signals
The system switch-on is acknowledged by two
flashes.
The side lights remain switched on while the
system is switched on.