BMW 2 Series Owner's Handbook Manual page 241

Adjusting the upper body
temperature
General
The air temperature in the upper body area
can be adjusted.
The set interior temperature for driver and
front passenger is not changed by this.
Adjusting the upper body temperature
1. "CLIMATE MENU"
2. "Settings"
3. "Temp. adjustment upper body"
4. Increase or decrease the temperature.
Air conditioning function
Principle
The air in the interior is cooled and dried and
then heated again depending on the tempera-
ture setting.
Operating requirements
Standby state or drive-ready state is switched
on.
Switching the cooling function on/off
1. "CLIMATE MENU"
2. "A/C"
3. Select the desired setting.
Depending on the weather conditions, the
windscreen and the side windows may mist
over for a short time after switching on drive-
ready state.
Cooling produces condensation, which then
exits underneath the vehicle.
Online Edition for Part no. 01405A5E758 - VI/22
Air conditioning
Maximum cooling
Principle
The function enables quick and intense cooling
of the interior.
General
The system is set to the lowest temperature,
maximum amount of air and air recirculation
function.
Automatic rear air-conditioning system:
The function is automatically activated in the
rear when the SYNC programme is turned on.
Operating requirements
The function is available at an outside temper-
ature above approximately 0 ℃, 32 ℉ and
when drive-ready state is switched on.
Turning maximum cooling on/off
1. "CLIMATE MENU"
2. "MAX A/C"
3. Select the desired setting.
The air flows from the air vents for the upper
body area. Open the vents.
Air recirculation function
Principle
If the air outside the vehicle has an unpleasant
odour or contains pollutants, the supply of out-
side air into the interior of the vehicle can be
shut off. The interior air is then recirculated.
General
If there is condensation, switch off the air recir-
culation function.
When the air recirculation function is turned off,
outside air is directed into the interior.
CONTROLS
241