BMW 2 Series Owner's Handbook Manual page 295

Checking and adjusting the tyre
inflation pressure
Checking
1. Switch off compressor.
2. Read off the tyre inflation pressure as
shown on the tyre pressure indicator.
To continue the journey, a tyre inflation pres-
sure of at least 2 bar must be reached.
Removing and storing the tyre sealant
bottle
1. Unscrew the filler hose of the tyre sealant
bottle from the tyre valve.
2. Press the red unlocking device.
3. Remove the tyre sealant bottle from the
compressor.
4. Pack and store the tyre sealant bottle to
avoid soiling the luggage compartment.
Minimum tyre inflation pressure is not
reached
1. Remove the plug from the socket inside the
vehicle interior.
2. Drive forwards and backwards by 10 m,
400 inches, to distribute the tyre sealant in
the tyre.
3. Screw the connecting hose of the compres-
sor directly onto the tyre valve.
Online Edition for Part no. 01405A5E758 - VI/22
Wheels and tyres
4. Insert the plug into the socket inside the
vehicle interior.
5. With standby or drive-ready state turned
on, turn on the compressor and let it run
for a maximum of 10 minutes.
If a tyre pressure of at least 2 bar is not
reached, contact a Service Partner of the
manufacturer, or a qualified Service Part-
ner, or a specialist workshop.
If a tyre pressure of at least 2 bar is
reached, see Minimum tyre inflation pres-
sure is reached.
6. Unscrew the connecting hose of the com-
pressor from the tyre valve.
7. Remove the plug from the socket inside the
vehicle interior.
8. Stow the tyre repair kit in the vehicle.
Minimum tyre inflation pressure is
reached
1. Unscrew the connecting hose of the com-
pressor from the tyre valve.
2. Remove the plug from the socket inside the
vehicle interior.
3. Stow the tyre repair kit in the vehicle.
4. Immediately drive for approximately
10 km/5 mi to evenly distribute the tyre
sealant in the tyre.
Do not exceed a speed of
80 km/h/50 mph.
If possible, do not drive slower than
20 km/h/12 mph.
MOBILITY
295