BMW 2 Series Owner's Handbook Manual page 205

When the system is switched on, the current
speed is maintained and stored as the set
speed.
The stored speed is displayed on the speed-
ometer.
If necessary, the Dynamic Stability Control will
be turned on.
The speed can also be stored by pressing the
button.
Press the key.
Changing the speed
Press the rocker switch repeatedly up or down
until the set speed is set.
If the system is active, the displayed speed is
stored and the vehicle adjusts to the stored
speed when the road is clear.
▷ Each time the rocker switch is tapped to the
resistance point, the set speed is increased
or decreased by 1 km/h, 1 mph.
▷ Each time the rocker switch is pressed past
the resistance point, the set speed changes
by 10 in the km/h display or 5 in the mph
display in the speedometer.
The maximum speed which can be set de-
pends on the vehicle.
▷ When the rocker switch is pressed to the
resistance point and then held there: the
vehicle accelerates or decelerates without
the need to press the accelerator pedal.
When the rocker switch is released, the ve-
hicle maintains the final speed. Pressing
Driver assistance systems
Online Edition for Part no. 01405A5E758 - VI/22
beyond the resistance point accelerates the
vehicle more rapidly.
Resuming Cruise Control
If Cruise Control is interrupted, it can be re-
sumed by calling up the stored speed.
Before calling up the stored speed, make sure
that the difference between the current speed
and the stored speed is not too great. Other-
wise, there may be unintentional deceleration
or acceleration.
With the system interrupted, press the
button.
Cruise Control is resumed with the stored val-
ues.
In the following instances, the stored speed
value is deleted and therefore cannot be called
up again:
▷ When the system is switched off.
▷ When drive-ready state is switched off.
Displays in the instrument cluster
Display in the speedometer
Depending on the equipment, a mark in the
speedometer displays the status of the sys-
tem.
▷ Green marker: system is ac-
tive, the marker shows the
set speed.
▷ Grey marker: system is inter-
rupted; the marker shows the
stored speed.
▷ No marker: system is switched off.
CONTROLS
205