BMW 2 Series Owner's Handbook Manual page 111

Turning the steering wheel heating
on/off
Press the button.
A Check Control message is shown.
If a journey is resumed within about 15 minutes
after a temporary stop, steering wheel heating
switches on automatically provided that the
function had been active at the end of the pre-
vious journey.
Memory function
Principle
The memory function enables the following
settings to be stored and retrieved when re-
quired:
▷ Seat position.
▷ Exterior mirror adjustment.
▷ Depending on the equipment: height of the
Head-up display.
General
For each driver profile, two memory slots can
be assigned with different settings.
The following settings are not saved:
▷ Backrest width.
▷ Lumbar support.
Safety information
WARNING
Using the memory function while driving may
cause the seat or steering wheel to move
unexpectedly. You could lose control of the
vehicle. There is a risk of accident. Only use
the memory function when the vehicle is at
standstill.
Seats, mirrors and steering wheel
Online Edition for Part no. 01405A5E758 - VI/22
WARNING
There is a risk of entrapment when the seats
are moved. There is a danger of injury or
material damage. Before making any adjust-
ment, make sure that the movement range of
the seat is clear.
Overview
The memory buttons are on the front doors.
Storing settings
1. Set the desired position.
2. Press the button. The LED is illumi-
nated.
3. Press the desired button 1 or 2 while the
LED is illuminated. A signal sounds.
Go to Settings
Press the desired button 1 or 2.
The saved position is retrieved.
The operation is halted when a seat set-
ting switch or one of the memory buttons is
pressed again.
The adjustment of the seat position on the
driver's side is interrupted after a short time
while driving.
CONTROLS
111