BMW 2 Series Owner's Handbook Manual page 202

CONTROLS
▷ When switching the engine off.
▷ When switching on Cruise Control.
▷ When activating some drive modes using
Driving Experience Control.
The displays goes out.
To interrupt the speed limiter
The system is interrupted in reverse gear or
when rolling backwards at idle.
Changing the speed limit
Press the rocker switch repeatedly up or down
until the desired speed limit is set.
▷ Each time the rocker switch is tapped to
the resistance point, the speed limit is in-
creased or decreased by 1 km/h, 1 mph.
▷ Each time the rocker switch is pressed be-
yond the resistance point, the speed limit
changes to the next multiple of 10 km/h
on the km/h display or the next multiple of
5 mph on the mph display in the speedom-
eter.
If the set speed limit is reached or unintention-
ally exceeded, for example when driving down-
hill, there is no active brake intervention.
If you set a speed during the journey which
is below the current speed, the vehicle deceler-
ates to the set speed limit.
The current speed can also be stored by
pressing the button:
Press the button on the steering wheel.
202
Driver assistance systems
Online Edition for Part no. 01405A5E758 - VI/22
Exceeding of speed limit
The system gives a warning if the vehicle's
speed exceeds the set speed limit.
You can intentionally exceed the speed limit.
To intentionally exceed the set speed limit,
press the accelerator pedal all the way down.
The limit automatically becomes active again
as soon as the current speed falls below the
set speed limit.
Warning when the speed limit is
exceeded
Visual warning
If the speed limit is exceeded: the in-
dicator light in the instrument cluster
flashes for as long as the set speed
limit is exceeded.
Acoustic warning
▷ A warning sounds if you inadvertently ex-
ceed the set speed limit.
▷ If the speed limit is reduced to below the
driven speed during the journey, the signal
sounds after a little time.
▷ No signal sounds if you intentionally exceed
the speed limit by fully pressing the acceler-
ator pedal.
Displays in the instrument cluster
Display in the speedometer
Depending on the equipment, a mark in the
speedometer displays the status of the sys-
tem.
▷ Green marker: system is ac-
tive.
▷ Grey mark: the system is in-
terrupted.
▷ No marker: system is
switched off.