BMW 2 Series Owner's Handbook Manual page 145

Front-collision warning restricted or
failed
Depending on the equipment and na-
tional-market version: functional limita-
tion detected, e.g. due to low sun or
system failure. It is possible to continue driv-
ing. Where applicable, observe the information
from Check Control messages.
For further information:
Front-collision warning, see page 174.
Front-collision warning switched off
Depending on vehicle equipment and
national-market version: the system is
switched off.
For further information:
Front-collision warning, see page 174.
Dynamic Stability Control regulating,
restricted or failed
Indicator light flashes: Dynamic Stabil-
ity Control controls the drive and brake
forces. The vehicle is being stabilised.
Decrease speed and adjust driving style to the
road conditions.
Indicator light is illuminated: Dynamic Stability
Control failure or initialising. No driving stabili-
sation.
Have the system checked immediately by a
Service Partner of the manufacturer or another
qualified Service Partner or a specialist work-
shop.
For further information:
Dynamic Stability Control, see page 194.
Dynamic Stability Control deactivated
or Dynamic Traction Control activated
Dynamic Stability Control is deactivated
or Dynamic Traction Control is activa-
ted.
Online Edition for Part no. 01405A5E758 - VI/22
Displays
For further information:
▷ Dynamic Stability Control, see page 194.
▷ Dynamic Traction Control, see page 196.
Flat tyre monitor
The Flat Tyre Monitor reports a tyre
pressure loss in a tyre.
Reduce your speed and carefully stop
the vehicle. Avoid heavy braking and sudden
steering manoeuvres.
For further information:
Flat Tyre Monitor, see page 304.
Tyre Pressure Monitor
Indicator light illuminates: the Tyre
Pressure Monitor is reporting a low tyre
inflation pressure or a flat tyre. Note
the information in the Check Control message.
Indicator light flashes and then illuminates
continuously: the system is unable to detect
flat tyres or tyre pressure losses.
▷ Fault due to systems or devices with the
same radio frequency: the system is auto-
matically reactivated upon leaving the field
of interference.
▷ For tyres with special approval: the Tyre
Pressure Monitor was unable to complete
the reset. Reset the system again.
▷ A wheel without wheel electronics is moun-
ted: if necessary have it checked by a Serv-
ice Partner of the manufacturer or another
qualified Service Partner or a specialist
workshop.
▷ Malfunction: have the system checked by
a Service Partner of the manufacturer or
another qualified Service Partner or a spe-
cialist workshop.
For further information:
Tyre Pressure Monitor, see page 297.
CONTROLS
145